Archive for the ‘Best Pressure Washer’ Category

PostHeaderIcon i need to get spraypaint off a plastic 4wheeler body, what is the best way?


i have a spray painted 4wheeler. it was red but he previous owner wanted to be "camo". what is the best way to remove the paint without messing up the plastic? Pressure Washer? scrubbing?

If the camo paint stuck, the ABS surface was probably prepped somehow. Probably have to rough or prime the surface for the color of your choice. Your best bets are either elbow grease and a scotchbrite pad, or wet sand with 500 or 600grit wet/dry sandpaper.
Good luck!

PostHeaderIcon What removes rust off of houses/ driveways the best?


What will remove rust from well water on the house and driveway? im using a Pressure Washer and some rust removing agent but it doesnt do the job i expect it too.. what works the best?

toilet bowl cleaner works wonders!!! it works almsot instantly and wont hurt the house. :))

PostHeaderIcon Roof snow removal with pressure washer


To remove snow from a steel roof I used a Pressure Washer with a zero tip. The pressure washer is powered by a 24 hp gas engine and generates 3000 psi at 7 gpm. Hard dry snow works the best. If the snow is wet it works best to pack it first.. Be careful to stand on the snow since the steel roof will be very slick. It’s also a good idea to plan a way down when you run out of snow to stand on.

Duration : 0:1:16

Read the rest of this entry »

Technorati Tags:

PostHeaderIcon What is the best way to clean an engine?

I have a 2001 Honda Accord and the engine is getting a little dirty. I want to clean it. I know that i shouldnt take a pressure washer to it cause certain parts you do not want to get wet. Whats the best way to clean it?

go to parts store, by some engine degreaser, it comes in a big aerosol can, with the engine cold, spray it on nd let it sit for about 10-15 minutes, either with a water hose or a pressure washer rinse it off.
using a Pressure Washer wony hurt anything as long as you dont get too close to actually break plastic parts, or blow stuff off. also if you use hose or pressure washer, make sure you dont spray water into carb or throttle body.